A set of 13mm diameter (ID) hardened steel dry vacuum pressing die set for pellet presses, ready for you to make 13mm diameter cylinder-shape pellets in a vacuum condition.
.jpg)
Die set includes
- Two 13mm ID core dies made of highly polished hardened steel
- One steel sleeve with vacuum connector
- One steel support plate
- One pushing rod
- Rubber sealing o-rings
- One steel cylinder pellet ejector
Important
- Always wear protection goggles and gear during operation
- Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
- Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 15 tons. Across International is not responsible for any damage caused by misuse.
Specifications
Maximum Pressure 15 tons Rockwell Hardness Rc 62 Diameter (ID) 13 mm Sleeve Height 40 mm Sleeve Diameter (OD) 39 mm Height 75 mm (assembled without sample) Tolerance 0.01-0.02 mm (10-20 micron) Material Core die & push rod: W18Cr4V hardened carbon tool steel
Sleeve, ejector & support: Cr12 hardened carbon mold steelMax sample fill height Not to exceed 1/3 of the sleeve height
