A set of 10mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 10mm diameter cylinder-shape pellets.
Die set includes
- Two 10mm ID cylinder-shape core dies made of highly polished hardened steel
- One steel sleeve
- One steel support plate
- One push rod
- One pellet ejector
Important
- Always wear protection goggles and gear during operation
- Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
- Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 10 tons. Across International is not responsible for any damage caused by misuse.
Specifications Specifications
Maximum Pressure 10 tons Rockwell Hardness Rc 62 Diameter (ID) 10 mm Height 61 mm (assembled without sample) Sleeve Height 39 mm Sleeve Diameter (OD) 30 mm Tolerance 0.01-0.02 mm (10-20 micron) Max sample fill height Not to exceed 1/3 of the sleeve height Material W18Cr4V hardened carbon tool steel Die set includes
- Two 10mm ID cylinder-shape core dies made of highly polished hardened steel
- One steel sleeve
- One steel support plate
- One push rod
- One pellet ejector
Important
- Always wear protection goggles and gear during operation
- Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
- Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 10 tons. Across International is not responsible for any damage caused by misuse.
