A set of 15mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 15mm diameter cylinder-shape pellets.
.jpg)
Die set includes
- Two 15mm ID cylinder-shape core dies made of highly polished hardened steel
- One steel sleeve
- One steel support plate
- One push rod
- One pellet ejector
Important
- Always wear protection goggles during operation
- Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
- Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 20 tons. Across International is not responsible for any damage caused by misuse.
Specifications
Maximum Pressure 20 metric tons Rockwell Hardness Rc 62 Diameter (ID) 15 mm Height 90 mm (assembled without sample) Sleeve Height 45 mm Sleeve Diameter (OD) 39 mm Tolerance 0.01-0.02 mm (10-20 micron) Material:
Core die & push rod
Sleeve, ejector & support
W18Cr4V hardened carbon tool steel
Cr12 hardened carbon tool steelMax sample fill height Not to exceed 1/3 of the sleeve height
